Uvdtf Instructions

How to apply UVDTF correctly

Step 1
Clean surfaces which you will be applying your UVDTF to, do not use alcohol. Ensure surface is at room temperature.

Step 2
Using a squeegee and a small amount of pressure, rub over both sides of your UVDTF to ensure that the design has properly transferred to the B film. 

Step 3
Slowly begin to peel the backing away from the film whilst taking care to make sure that the design has transferred to the B film fully. 

Step 4
Carefully place the design onto the prepped surface ensuring it is at room temperature and that it is positioned correctly as you will not be able to remove once placed.

Step 5
Rub over the surface of your UVDTF with a squeegee or tool to ensure that the design has transferred to the prepped surface sufficiently. Work from the centre outwards to remove any unwanted air bubbles. If any air bubbles are left, this will cause your transfer to lift.

Step 6 
Slowly peel back the B film to reveal the final design. 

Note: We recommend hand wash only to preserve your transfer